
Tri Band 1800MHz / 2100MHz / 2600MHz Cell Phone Signal Boosters Increase Signal Strength
Model. GW-20DWL-NH
Signal Booster Description:
Reasons Why Your Signal Is Weak
One of the reasons why your cell phone reception is weak could be due to the distance from the cellular tower closest to you. The closer you're to the cell tower, the stronger the cell phone signal received. On other hand, the farther you’re from the cellular tower of your carrier, the worse the cell phone signal. It is also possible external interferences are affecting your cellular coverage. Note that cellular signals are generally radio waves and obstructed a lot as they cover long distances to reach your phone.
Another thing that weakens the reception is internal interferences. These include such things as thick building materials like layers of brick and thick concrete, radiant barriers, glasses and metal, magnetic and electronic clutter as well as conductive materials that block or weaken an incoming coverage.
Signal Booster Introduction:
Signal Booster GW-20DWL-NH is designed to enhance and improve the quality of three band DCS 1800MHz / WCDMA 2100MHz / LTE 2600MHz connection. There’re black and white colors for options. This model is enough to provide reliable coverage of signal in the area of up to 800 m². It is recommended to use in offices, apartments, houses etc.
The model is equipped with an LCD screen in a nice and symmetrical body, which displays the current level of input signal. The information on the LCD screen, greatly simplifies the process of adjusting the gain of the system. The connectors under the screws allow to build device on a wall or other vertical surface.
Signal Booster Specification:
Frequency Range | Uplink | Downlink | |||
DCS 1800MHz | 1710 - 1785MHz | 1805 - 1880MHz | |||
WCDMA 2100MHz | 1920 - 1980MHz | 2110 - 2170MHz | |||
LTE 2600MHz | 2500 - 2570MHz | 2620 - 2690MHz | |||
Max. Gain | 65dB | 70dB | |||
Max. Output Power | 17dBm | 20dBm | |||
Band width | Wide Band | ||||
Manual Gain Control | 31dB / 1dB Step | ||||
Automatic Gain Control | >31dB | ||||
Ripple in Band | 8dB; | ||||
Noise Figure | ≤ 6dB | ||||
VSWR | ≤ 2.0 | ||||
Intermodulation Products | 9KHz~1GHz | ≤ -36dBm | |||
1~12.75GHz | ≤ -30dBm | ||||
Spurious Emission | 9KHz~1GHz | ≤ -36dBm | |||
1~12.75GHz | ≤ -30dBm | ||||
Time Delay | ≤ 1.5 μs | ||||
Frequency stability | ≤ 0.01ppm | ||||
MTBF | > 50000 hours | ||||
Impedance | 50 ohm | ||||
Power Supply | AC 90-264V,DC 9V/5A | ||||
Power LED | Power indicator | ||||
ISO(Alarm LED) | Red | Self oscillation or Strong input signal | |||
Green | Normal | ||||
Mechanical Specification | |||||
RF Connector | N-Female | ||||
Switch | Power Switch | ||||
Cooling | Heatsink Convection cooling | ||||
Humidity | < 90% | ||||
Operating Temperature | -20°C ~ +55°C | ||||
Environment Conditions | IP40 | ||||
Installation Type | Wall Installation | ||||
Size | 228mm×170mm×65mm | ||||
Weight | < 4.5Kg |
Other Frequencies for options:
Frequency Range | Uplink | Downlink |
EGSM900+DCS1800+WCDMA | 880 - 915/1710 - 1785/ 1920 - 1980MHz | 925 - 960/1805-1880/ 2110 - 2170MHz |
EGSM900+DCS1800+LTE2600 | 880 - 915/1710 - 1785/ 2500 - 2570MHz | 925 - 960/1805-1880/ 2620 - 2690MHz |
GSM900+DCS1800+LTE2600 | 890 - 915/1710 - 1785/ 2500 - 2570MHz | 935 - 960/1805-1880/ 2620 - 2690MHz |
EGSM900+WCDMA+LTE2600 | 880 - 915/1920 - 1980/ 2500 - 2570MHz | 925 - 960/2110 - 2170/ 2620 - 2690MHz |
GSM900+WCDMA+LTE2600 | 890 - 915/1920 - 1980/ 2500 - 2570MHz | 935 - 960/2110 - 2170/ 2620 - 2690MHz |
GSM850+PCS1900+AWS1700 | 824 - 849/1850 – 1910/ 1710 - 1755MHz | 869 - 894/1930 - 1990/ 2110 - 2155MHz |
GSM850+PCS1900+LTE2600 | 824 - 849/1850 – 1910/ 2500 - 2570MHz | 869 - 894/1930 - 1990/ 2620 - 2690MHz |
Signal Booster Features:
1. Coverage up to 800 m²
2. Manual mode for adjusting the gain by “+” / “-” button
3. Smart mode for adjusting the gain automatically
4. Fluted surface on aluminum shell provides an optimal cooling
5. LCD Screen displays the working status of AGC and ISO, gain and power in time.
Support any cellular devices (voice & data & video)
Signal Booster Instructions:
Power LED | Green | Normal |
Off | DC power problem | |
Smart LED | Green | Adjusting the gain automatically |
Off | Manual mode: adjusting the gain by “+” / “-” button | |
LCD Display | LCD display will show the real-time gain, “+” increase gain, “-” decrease gain. | |
SEL | 1. Quickly Press: select the different systems when you need, (only for Dual band, Tri band, Quad-band or Five band repeater) 2. Press for 2 Seconds: select the smart mode or manual mode |
FAQ:
1. After installing booster signal not be very good, indoor signal
coverage very small ?
> Adjust outdoor antenna's location and direction
> Change another high gain outdoor antenna
> Check whether cables are connected well
> Change more powerful repeater
2. Cell phone signal full bar, but communication quality bad ?
> Much closer distance between indoor and outdoor antenna,
separate them with a longer distance.
3. After installing booster not only signal be good, but also more
bad ?
> Much closer distance between indoor and outdoor antenna,
separate them with a longer distance.
4. Working good for long time, suddenly signal bad ?
> Check whether outdoor cable connectors are flooded
> Check whether power light is working normally
> If cables are not flooded and power light is working normally,
the booster should has problems and need to be sent back to factory
for repair.
Application:
Signal Booster Installation:
The booster is fixed onto the wall through expansion bolts.
A. Drill holes on the targeted place and install expansion bolts.
B. Align the holes with the expansion bolts, place flat washers,
spring washers, and nuts in turn, and tighten the nuts to fasten
the installing support.
C. Place the booster on and fasten it.
D. Connect cables and power cables to the booster respectively.
E. After installing the booster as described above, power on the
booster to check the operation status.
Signal Booster Connection:
A. BTS Port: donor antenna cable is connected with Outdoor Port;
B. MS Port: service whip antenna is connected with Indoor Port;
C. DC IN: connected with Power adaptor.
Our Signal Booster Workshop:
Our Company:
Greetwin Tech is a strong and reliable factory, focusing on the R&D and Manufacturing of Digital ICS Repeater, RF Repeater, Indoor Signal Distribution System, Trunk Amplifier, Band Selective Repeater for more than 10 years.
Shenzhen Greetwin Technology Co.,Limited
Shenzhen Greetwin Technology Co., Limited is one of the leading suppliers which specializes in designing and
manufacturing RF Jamming Equipment and Wireless Coverage Products.
Wireless Coverage Products include 2G 3G 4G LTE 5G RF
Repeater.
The RF Repeater solutions will bring smooth and clear
calls, support all bandwidths and mobile standards including TETRA,
iDEN, LTE700, GSM850, EGSM, GSM900, DCS1800, PCS1900, CDMA800,
CDMA450, LTE 4G, CDMA2000, 3G(WCDMA), LTE2600 and TDD-LTE series.
Such as, Wide band Repeater, Band selective Repeater, Digital Repeater, High Power Outdoor Repeater, Fiber Optic Repeater, ICS Repeater, Consumer Signal Booster, Power Amplifier.
We are committed to providing the best solutions for mobile operators, offering OEM and ODM service. Products can be customized according to different operators in the world and the output power are available from 0.01W to 20W.
RF Jamming Equipment include Cell Phone Signal Jammer,
RF Communication Jammer(20-6000MHz) and 20-200W Power amplifier.
GREETWIN is the foremost innovator in the field of RF
jamming, offering a comprehensive range of jamming equipment and
systems which have a proven record of reliability and performance
in all types of applications and environmental conditions.
In countering the ever-growing threat of remotely
controlled improvised explosive devices (RCIEDs), we has invested
heavily in the development of a range of multi-band,
very-high-power jamming systems for the protection of troop
transportation, military and police checkpoints, large governmental
establishments, bomb disposal squads and VIP convoys.
Such as, 5KM Drone jammer, UAV jammer, High power bomb
jamming devices, Military IED jammers, Digital programable jammer,
VIP Convoy Bomb Jammers (RCIED Jammers), Mobile Phone Signal
Jammers, Prison Jammers, Portable Jammers, Handheld Jammers, to
suit all types counter terrorism activities.
Our clients are government agencies, military, SWAT
team, prison, school, bank, law enforcement and VVIPs. We also
serve corporations and private individuals who must take
responsibility for protecting assets, proprietary information,
executives and family members.
GREETWIN products have been exported to more than 60
countries and regions around the world. Such as Southeast Asia,
Africa, Europe, South America and the Middle East.
Let us hand in hand and create a glorious cause!